JVC CA-MXJE3 - Manual (Page 10)

8
Listening to the Radio
To select the AM tuner interval spacing
Some countries space AM stations 9 kHz apart, and other
countries use 10 kHz spacing.
You can change the AM tuner intervals during the unit is on
standby mode.
To select the band (FM/AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency search stops.
• When you repeatedly press the button, the frequency
changes step by step.
To stop searching manually, press either button.
If the received FM station is hard to listen
To preset Stations
You can preset 30 FM and 15 AM stations.
1 Tune in to a station you want to preset.
2 Select a preset number.
3 Store the station.
To tune in to a Preset Station
1 Select the band (FM or AM).
2 Select a preset number for the station you store.
The MONO indicator lights on
the display. Reception will
improve though stereo effect is
lost—monaural reception mode.
To restore the stereo effect,
press the button again (the
MONO indicator goes off).
INFO
Main Unit
ONLY
(holding then...)
FM AM
Increases the frequencies.
Decreases the frequencies.
1 sec.
Remote
ONLY
Examples:
To select preset number 5, press 5.
To select preset number 15, press
+10, then 5.
To select preset number 30, press
+10, +10, then 10.
• You can also use 4 / ¢
buttons on the remote control or
the PRESET +/– buttons on the
main unit.
Main Unit
ONLY
SET
/ DISPLAY
ST
PRESET
ST
SET
/ DISPLAY
ST
FM AM