JVC LVT2016-001D - Manual (Page 12)

8
Remote Control Function
Remote Control A/B/C/D Code Switching
The remote control is capable of controlling four
JVC video units independently. Each of the units
can respond to one of four codes (A, B, C or D).
The remote control is preset to send C code sig-
nals because your unit is initially set to respond to
C code signals. You can easily modify your unit to
respond to A, B or D code signals.
1. Press STANDBY/ON (1/&) on the unit to turn
off the unit with no video tape inserted.
2. Press the number key “1” for A, “2” for B, “3” for
C or “4” for D while pressing ENTER ( ) down
on the remote control.
3. Press N/`` on the unit for over 5 seconds
while the unit is turned off. The current code
appears on the display window.
4. Press STOP (x) on the remote control, the cur-
rent code on the display window changes to
new code and blinks for approximately 10 sec-
onds.
5. The new code setup on unit and remote is
done.
Note:
If you change the batteries of the Remote Control
with A, B or D code, the remote control code is set
to C automatically. In this case, you should reset
the remote control code described above.
RM-SDRMV150A RM-SDRMV150A
STANDBY/ON (1/&)
Number 1-4
STOP ( x )
ENTER ( )
B/``