John Lewis JLWD 1406 1400 - Manual (Page 11)

11
1 Detergent dispenser drawer
2 Programme selector dial
The programme selector dial is divided into the
following sections:
• Cottons,
• Synthetics,
• Delicates
• Wool / Hand washing
• Special programmes from “Soak 30°” to “30
Minute wash”
• Reset programme/Switching the machine Off Off
The selector dial can be turned either clockwise or
anticlockwise to select the required wash and drying
programme .
Positions “Economy” correspond to an ENERGY
SAVING programme and “Cold” to a cold wash.
Before setting the dial to any position ensure that the
machine is switched off.
Important!
At the end of the programme the selector dial
must be turned to position “Off”.
60°
40°
Economy 40°
Easy iron 40°
Cold
30°
40°
90°
Economy 60°
Economy 40°
60°
40°
30°
Drying
30 Minute wash
Spin
Drain
Softeners
Rinse
Soak 30°
Delicates 30°
Off
Drying
Duvets 40°
Cottons
Synthetics
W
ool
The control panel
1 2 3 4 5 6 910 7 8
End 60°
40°
Economy 40°
Easy iron 40°
1400
900
700
500
Start/
Pause Spin
Prewash
Wash
Rinse
Rinse hold
Drain
Spin
Drying
Prewash
Delay
start Quick
Automatic
dry
Programme time
None
Time
dry
Extra dry
Store dry
Iron dry
Cold
30°
40°
W
ool
90°
Economy 60°
Economy 40°
60°
40°
30°
Drying
Cottons
Synthetics
30 Minute wash
Spin
Drain
Softeners
Rinse
Soak 30°
Delicates 30°
Off
Drying
JLWD1406
Extra
rinse
Delicates 40°
3 “Spin” button
Press this button repeatedly to change the spin speed,
if you want your laundry to be spun at a speed
different from the one proposed by the washer-dryer
or to select position “None”. The relevant light will
light up.
Spin speed
The following speeds are available for the different
fabrics:
• Cottons, linen:
500/700/900/ max 1400 r.p.m.;
• Synthetics and wool:
500/700 max 900 r.p.m.;
• Delicates and “30 Minute wash”: 700 r.p.m.
Position “None”
By selecting the option “None” all the spinning phases
are cancelled and replaced by a drain.
If you select this option with programmes for cotton
and synthetics, the machine will perform some extra
rinses (3 for cotton and 1 for synthetics). To be used
for extremely delicate items.
4 “Option” buttons
Depending on the programme, different functions can
be combined. These must be selected after choosing
the desired programme and before depressing the
“”Start/Pause” button.
When these buttons are pressed, the corresponding
pilot lights illuminate. When they are pressed again, the
pilot lights go out.
If an incorrect option is selected, the pilot lights flash
for about 2 seconds and the message Err is displayed.
Press these buttons to select the following options: