JVC HR-J668EU - Manual (Page 38)

38
EN
1 2 3
4 5 6
7 8 9
0
2
4
1
3
?
SUBSIDIARY SETTINGS (cont.)
ATTENTION
Guide Program numbers are not set when channels are
stored manually. If an attempt is made at timer program-
ming with S
HOW V IEW in this state, the “GUIDE PROG SET”
screen appears; set the Guide Program numbers on this
screen.
੬
“ATTENTION – Regarding Guide Program
Number Set” on pg. 23.
Or perform “Guide Program Number Set” (
੬
pg. 46).
NUMBER
Storing Channels Manually
Store channels that were not stored during Auto Set Up (
੬
pg.
4), Preset Download (
੬
pg. 6) or Auto Channel Set (
੬
pg. 36).
SELECT BAND
4
Press
%fi to change the
band between CH (regular)
and CC (cable), then
press
#
.
INPUT CHANNEL
5
Press the NUMBER keys to input the channel number you
want to store.
● Input "0" before any single number entries.
● To input the registered station name (ID – ੬
pg. 41),
press
#
until "----" (ID setting) begins blinking, then
press %fi.
● For fine tuning adjustment, press #
until "+/–" begins
blinking, then press
%fi. While tuning, “+” or “–”
appears.
● When storing a channel that sends scrambled
broadcasts, press
#
until "OFF" (Decoder setting)
blinks, then press %fi to set "DECODER" to "ON"
("OFF" is the default setting).
● When "AV2 SELECT" is set to "AV2", the "DECODER"
setting cannot be changed (
੬
pg. 31).
ENTER NEW CHANNEL
INFORMATION
6
Press OK and the Confirmation screen appears.
● Repeat steps 3 through 6 as necessary.
CLOSE CONFIRMATION
SCREEN
7
Press MENU.
● To change positions, see "Change Station Channel
Position" (
੬
pg. 39).
● If you wish to set station names other than the ones
registered in your recorder,
੬
"Set Stations (B)" on
page 40.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
ACCESS MAIN MENU
1
Press MENU.
ACCESS CONFIRMATION
SCREEN
2
Press %fi to move the highlight bar (pointer) to
“MANUAL CH SET”, then press OK or
#
. The Confir-
mation screen appears.
SELECT POSITION
3
Press %fi @ #
until an
open position in which
you want to store a
channel begins blinking,
then press OK. The
Manual Channel Set
screen appears.
(Ex.) To store in position 12.
∞ ∞
PR CH ID PR CH ID
01 25 ARD 08 C26 E-SP
02 CDB SKY1 09 55 WEST
03 10 ZDF 10 C24 SAT1
04 C65 RAI1 11 C23 OSF
05 C31 BBC1 12 – – – –
06 C32 BBC2 13 – – – –
07 C33 3SAT 14 – – – –
[ 5∞ ]
= : EDIT
= [X] : DELETE
[MENU] : EXIT
PR CH ID FINE DECODER
12 CH01 – – – – +/– OFF
[ 5∞] : SELECT
[ ] : CURSOR +=
: OK
[MENU] : EXIT
∞ ∞
OK
MENU