JVC TH-A32 - Manual (Page 17)

15
To turn off the sounds temporarily
From the remote control ONLY:
Press MUTING.
To restore the sound, press MUTING again.
• Pressing AUDIO VOL + or – also restores the sound.
6
Activate Surround or DSP Mode
You can enjoy Dolby Pro Logic II mode and DSP modes.
Dolby Pro Logic II—Pro Logic II Movie and Pro
Logic II Music
To activate Pro Logic II modes
Press SURROUND.
The current Pro Logic II mode appears on the display
for a while.
• Each time you press the button, Pro Logic II mode
changes as follows:
• When Dolby Pro Logic II mode is activated, the PRO LOGIC
II indicator lights up on the display.
– For in-depth information about Dolby Pro Logic II modes, see
“Creating Realistic Sound Fields” on pages 21 to 22.
DSP modes—CONCERT, STADIUM, HALL,
THEATER, LIVE HOUSE
DSP modes take effect only when you enjoy a disc recorded using
Linear PCM.
To activate DSP modes
Press DSP.
The current DSP mode appears on the display for a
while.
• Each time you press the button, DSP mode changes
as follows:
– For in-depth information about DSP modes, see “Creating
Realistic Sound Fields” on pages 21 to 22.
Note:
Before activating the Surround or DSP mode, adjust the speaker
setting to bring out the best performance from this system.
For in-depth information about adjusting the speaker setting, see
“Setting Menu” on pages 53.
7
Stop Playback
Press 7 twice.
Playback stops completely.
• This system can memorize the end point even when
you press 7 once. When you start playback again by
pressing 3, playback begins from where it has been stopped—
Resume play.
To remove the loaded disc
Press 0.
“OPEN” appears on the display and the disc tray comes
out.
To close the disc tray, press 0 again.
To prohibit disc ejection
On the front panel ONLY:
Press and hold
6 and 4 for more than
3 seconds.
“LOCKED” appears on the display, and the
disc tray is locked.
To cancel the prohibition, press and hold
6 and 4 for more than 3 seconds.
“UNLOCK” appears on the display, and the
disc tray is unlocked.
To turn off the power (into standby)
Press AUDIO (or
STANDBY/ON on the front panel).
The illumination lamp goes off and the STANDBY lamp
lights up.
• If you press AUDIO
(or STANDBY/ON on the front
panel) while the disc tray is kept open, the disc tray closes
automatically, then the system is turned off.
• A small amount of power is consumed even in standby mode. To
turn the power off completely, unplug the AC power cord.
AUDIO
MUTING
LIVE HOUSE
STADIUM
CONCERT
THEATER DSP OFF
HALL
DSP
SURROUND
PL II MUSIC PL II MOVIE
PL II OFF
EN10-20TH-A35[J].pm6 03.2.3, 4:03 PM 15