Jensen Tools AWM 960 - Manual (Page 3)

AWM960
3
Installation
Select Mounting Location
Select a mounting location, taking care to avoid the following:
•
Places exposed to heat-radiating app liances such as electric heaters
• Adjacent to other equipment that radiates heat
• Poorly-ventilated or dusty places
• Moist or humid locations
Preparing the Opening
Use the mounting hole diagram (below) to measure and cut a mounting hole, and mount the unit using
the four 3x20min self-tapping screws provided.
Note: Before cutting the mounting hole, make sure the area behind the mounting location is
clear of wires and fuel, vacuum and or brake lines.
Mounting the Radio
Route power, speaker and antenna cables through t he hole, and connect them to the unit as outlined
in the wiring diagram. After ensuring correct connections, test operation.
Mounting Hole Diagram