Jensen CR1610 User Manual
Cr1610 owner’s manual
LO/DX
LOUD
CD
CONTROLLER
CR1610
HIGH POWER AMPLIFIER
AM/FM/CDC/CASSETTE RECEIVER
LO/DX
LOUD
CD
CONTRO
LLER
CR1610
HIGH
POWER
AMPLIFIER
AM/F
M/CD
C/CA
SSET
TE RE
CEIVE
R
CR1610
Owner’s Manual
Thank You!
Thank you for choosing a Jensen product. We hope you will find the instructions in this
owner’s manual clear and easy to follow. If you take a few minutes to look through it, you’ll
learn how to use all the features of your new Jensen receiver for maximum enjoyment.
Preparation ................................................................................................................. 1
Wiring .......................................................................................................................... 3
Installation .................................................................................................................. 5
Operation .................................................................................................................... 8
Tuner Operation ........................................................................................................ 13
Tape Player Operation .............................................................................................. 16
CD Changer Operation ............................................................................................. 17
Care and Maintenance .............................................................................................. 19
Specifications ............................................................................................................ 20
Warranty..................................................................................................................... 22
Preparation
Getting Started
It’s a good idea to read all of the instructions before beginning the installation.
Tools and Supplies
The following tools and supplies are needed to install the radio.
•
Torx type, Flat and Philips screwdrivers
•
Wire cutters and strippers
•
Tools to remove existing radio (screwdriver, socket wrench set or other tools)
•
Electrical tape
•
Crimping tool
•
Volt meter/test light
•
Crimp connections
•
18 gauge wire for power connections
•
16-18 gauge speaker wire
Speaker Requirements: Only connect speakers rated with a load impedance of 4 ohms.
Speakers with a load impedance of less than 4 ohms could damage the unit.
Disconnect Battery
Before you begin, always disconnect the battery negative terminal.
Remove Radio from Sleeve
Lift latches on both sides of sleeve to remove half-sleeve from radio.
Audiovox Electronics Corporation
150 Marcus Boulevard
Hauppauge, NY 11788
1-800-323-4815
www.jensen.com
© 2005 Audiovox
v.123104
Remove Radio from Sleeve
Remueva el Radio de la Manga
Enlever la radio du manchon