JVC HM-DT100U - Manual (Page 29)

Masterpage:Right-FullCol
EN
29
Filename [HM-100U_Eng_05Index.fm]
Basic Playback
Features A
Checking tape position
The position of “Z” in relation to “B” (Beginning) or “E”
(End) shows you where you are on the tape.
NOTES:
• “SUPERIMPOSE” must be set to “ON”, or the indicator will
not appear (
A page 68).
• It may take a few seconds for the tape position indicator to be
displayed.
To reset the time counter, press [C. RESET] on the
Remote. The counter reading becomes “0:00:00”. It is
also reset when a tape is inserted.
B
Playing back tape repeatedly
— Repeat Playback
You can play back a tape repeatedly (50 times).
While playing back a tape, press and hold [PLAY (I)] for
more than 5 seconds.
The play indicator [E] on the front display panel starts
flashing slowly, and a tape will be played back 50 times.
To stop playback, press [STOP (L)] on the Remote or on
the front panel.
NOTE:
For a cassette recorded in D-VHS mode, Repeat Playback is not
possible if the cassette was recorded in LS3 mode.
• Turn on the VCR and the TV, and select the AV
mode on the TV.
• Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
IN F–1
E
[PLAY I)] E C
[STOP (L )]
[POWER]
[TIMER ( )]
[FF (N)]
[REW (O )]
[S] [T]
[C.RESET]
C
G
D
B E G
VCR
TV
CABLE
/DBS
The tape position indicator
appears on the screen in the
following cases:
• When you change the VCR
operation mode from the
stop mode to fast forward
or rewind mode.
• When you perform an
Index Search (A page 31).
B E
HM-DH100U_Eng.book Page 29 Thursday, August 5, 2004 1:54 PM