JVC 0305MKH-CR-MU - Manual (Page 132)

Troubleshooting
41
AV-32/28H5SK / LCT1806-001A-U / English
• Have the COLOUR and BRIGHT settings
been adjusted properly? Follow the
description “BRIGHT” and “COLOUR”
on page 22 to try to adjust them properly.
• Videotaping teletext is not recommended
because it may not record correctly.
• When a white and bright still image (such
as a white dress) is displayed on the
screen, the white part may look as if it
were coloured. This is unavoidable due to
the nature of the picture tube itself, and is
not a fault. When the picture disappears
from the screen, the unnatural colours will
also disappear.
• When viewing images from commercially
available video software products, or
videos from videotapes which have been
recorded improperly, the top of the image
may be distorted. This is due to the
condition of the video signal, and is not a
TV fault.
„ Poor sound
• Have you adjusted BASS or TREBLE
properly? If not, follow the description
“BASS” or “TREBLE” on page 25.
When the TV channel reception is poor, it
can be hard to hear the stereo or bilingual
sound. In this case, follow the description
“STEREO / I • II” on page 25 to hear the
sound more easily by changing it to a mono
sound.
„ Operation disabled
• Have the batteries of the remote control
become exhausted? Follow the
description “Putting the batteries into the
remote control” on page 7 and replace
them with new batteries to try to solve the
problem.
• Have you tried to use the remote control
from the sides or rear of the TV or from
more than seven metres away? Use the
remote control in front of your TV and
less than seven metres away to try to solve
the problem.
• When you are viewing a teletext
programme, you cannot operate the
menus. Press the b button to return to
the ordinary TV programme and then try
operating the menus.
• If the TV operation becomes disabled
suddenly, press the Main power button on
the TV and turn off the main power. Try
to press the Main power button again to
turn on the main power. If the TV returns
to a normal state, it is not a failure.
„ Other concerns
• When the SLEEP TIMER function
operates, the TV is automatically turned
off. If the TV is turned off suddenly, try to
press the # (Standby) button to turn on
the TV once again. At this time, if the TV
resumes a normal state, there is no
problem.
• When a WSS (wide screen) signal is
included in the broadcast signal or the
signal from an external device, or when
the TV is receiving a control signal from
an external device, the ZOOM mode will
change automatically. When you want to
return to the previous ZOOM mode, press
the c button to choose the ZOOM
mode again.
AV-32&28H5SK_Eng.book Page 41 Wednesday, February 16, 2005 10:19 AM