JVC RX-5022VSL - Manual (Page 31)

29
Operating Other Manufacturers' Video Equipment
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
ent
To change the transmittable signals for
operating a DVD player
1 Press and hold STANDBY/ON DVD.
2 Press DVD.
3 Enter manufacturer’s code using buttons 1–9,
and 0.
4 Release STANDBY/ON DVD.
Now, you can use the following buttons on the DVD player.
STANDBY/ON DVD : Turn on or off the DVD player.
After pressing DVD (source selecting button), you can use the
following buttons on the DVD player:
3 : Start playback.
7 : Stop playback.
¢ : Skip to the beginning of the next track.
4 : Return to the beginning of the current
(or previous) track.
8 : Pause playback. To release it, press 3.
DVD menu operations
After pressing DVD (source
selecting button), you can use the
following buttons for DVD menu
operations:
MENU : Display or erase the menu screen.
5 5 5 5 5/∞ ∞ ∞ ∞ ∞/3 3 3 3 3/2 2 2 2 2 : Select an item on the menu screen.
ENTER : Enter a selected item.
5 Try to operate your DVD player by pressing
STANDBY/ON DVD.
When your DVD player turns on or off, you have entered the
correct code.
TEST
EFFECT
MENU
ENTER
CENTER
REAR L
SUBWOOFER
REAR R
1
4
7/P
10
2
5
8
0
3
6
9
10
100 RETURN
Manufacturer Codes
JVC 01*, 02, 03
Emerson 10, 22
Gold Star 11
Hitachi 04
Mitsubishi 12
NEC 21
Panasonic 07, 13
Philips 09
RCA 05, 06
Samsung 20
Sanyo 17, 18, 19
Sony 14, 15, 16
Zenith 08
Manufacturers’ codes for VCR
*Initial setting
Manufacturer Codes
JVC 01*
Panasonic 02
Philips 04
Pioneer 03
Sony 05
Toshiba 06
Yamaha 07
Manufacturers’ codes for DVD player
*Initial setting
To change the transmittable signals for
operating a VCR
1 Press and hold STANDBY/ON VCR.
2 Press VCR.
3 Enter manufacturer’s code using buttons 1–9,
and 0.
4 Release STANDBY/ON VCR.
Now, you can perform the following operations on the VCR.
STANDBY/ON VCR : Turn on or off the VCR.
VCR CH +/– : Change the channels.
After pressing VCR (source selecting button), you can use the
following buttons on the VCR:
3 : Start playback.
FF : Fast-wind a tape.
REW : Rewind a tape.
7 : Stop playback or recording.
8 : Pause playback. To release it, press 3 3 3 3 3.
REC PAUSE : Press this button to enter recording
pause.
Press this button then
3 3 3 3 3 to start
recording.
Note:
Refer also to the manual supplied with your VCR.
5 Try to operate your VCR by pressing
STANDBY/ON VCR.
When your VCR turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of
VCR, try each one until the correct one is entered.
EN24-32.RX-5020/5022V[J]_f 01.12.7, 8:51 AM 29