Using bluetooth ® devices, Registration (pairing) methods – JVC GET0626-001B User Manual

Page 10

Advertising
background image

10

ENGLISH

Using Bluetooth ® devices

For Bluetooth operations, it is required to
connect the Bluetooth adapter, KS-BTA200 (not
supplied) to the expansion port on the rear of
this unit.
• Refer to pages i and ii at the end of the

manual to check the countries where you
may use the Bluetooth ® function.

• For details, refer also to the instructions

supplied with the Bluetooth adapter and the
Bluetooth device.

To use a Bluetooth device through the unit
(“BT-PHONE” and “BT-AUDIO”) for the first time,
you need to establish a Bluetooth wireless
connection between the unit and the device.
• Once the connection is established, it is

registered on the unit even if you reset your
unit. Up to five devices can be registered in
total.

• Only one device can be connected at a time

for each source (“BT-PHONE” and “BT-AUDIO”).

Registration (Pairing) methods

Use either of the following items (“OPEN” or
“SEARCH” ) in the Bluetooth menu to register
and make the unit ready to establish a new
Bluetooth connection with a device.
“OPEN”

: Connection is established by

operating the Bluetooth device.

“SEARCH” : Connection is established by

operating the unit.

Registering using “OPEN”

Preparation: Operate the device to turn on its
Bluetooth function.

1

] “BT-PHONE” or “BT-AUDIO”

2

] “NEW DEVICE” ] “OPEN”

3

] Enter a PIN (Personal Identification
Number) code in to the unit.
You can enter any number you like
(1-digit to 16-digit number).
[Initial: 0000]
• Some devices have their own PIN

code. Enter the specified PIN code in
to the unit.

4

Repeat step 3 until you have finished
entering the PIN code.

5

“OPEN..” flashes.

6

Use the Bluetooth device to search and
connect.
On the device to be connected, enter
the same PIN code you have just
entered for this unit. “CONNECTED”
appears.
Now connection is established and you
can use the device through the unit.

The device remains registered even after you
disconnect the device. Use “CONNECT“ (or
activate “AUTO CNNCT”) to connect the same
device from next time on. (

11, 14)

EN10-19_KD-A315_R310[J]5.indd 10

EN10-19_KD-A315_R310[J]5.indd 10

9/17/09 9:23:47 AM

9/17/09 9:23:47 AM

Advertising