John Lewis JLFZW1812 - Manual (Page 17)

As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the
terminals in your plug, proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter “E“ or by the earth
symbol or coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
“N“ or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
“L“ or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp 4 is
secure over the outer sheath.
5. Make sure the electricity supply voltage
is the same as that indicated on the
appliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug
fitted
2 . In the event of having to change
the fuse in the plug supplied, a 13 amp ASTA
approved (BS 1362) fuse must be used.
Warning! A cut off plug inserted
into a 13 amp socket is a serious
safety (shock) hazard. Ensure that it is
disposed of safely.
Rear spacers
Inside the appliance you find two
spacers which must be fitted as shown
in the figure.
Slacken the screws and insert the spacer
under the screw head, then retighten the
screws.
Door reversibility
Warning! Before carrying out any
operations, remove the plug from the
power socket.
To carry out the following operations, we
suggest that this be made with another
person that will keep a firm hold on the
door of the appliance during the operations.
Gently lay the appliance on its back.
To change the opening direction of the
door, do these steps:
1. Remove the clip-in ventilation grille,
remove the plug (e) from the ventilation
grille and install it on the opposite side.
2. Remove the bottom hinge (A) by
unscrewing the fixing screws.
17