Assembling the cutting equipment, Fitting the trimmer guard and trimmer head, Assembly – Jonsered GT2123 User Manual
Page 10
10 –
English
ASSEMBLY
Assembling the cutting equipment
Fitting the trimmer guard and trimmer
head
•
Attach the cord cutter (A) to the trimmer guard using two
M5x16 screws, locking washers and nuts as shown.
•
Fit the guard (B) to the gear housing (C) using the support
plate (D) and two screws.
•
Turn the output shaft until one of the holes in the drive disk
aligns with the corresponding hole in the gear housing.
•
Insert the locking pin (E) in the hole to lock the shaft.
•
Screw on the trimmer head (F) in the opposite direction to
the direction of rotation.
•
Remove the locking pin.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
A
B
C
D
E
F