Jura Capresso Impressa 68193 - Manual (Page 31)

If you push the Rotary Dial to enter one of the above programs,
the display guides you through the necessary steps.
Please note: If the display shows
MAINTENANCE and you do
not select one of the above programs within five seconds, the
S9 OT will return to
COFFEE READY .
Example:
Run a manual hot water rinse cycle.
COFFEE READY .
• Push the Rotary Dial until the display shows MAINTENANCE .
• Push the Dial again, CLEAN CAPPUCCINO .
• Turn the Dial until the display shows RINSE MACHINE .
• Place a cup under the Dual Coffee Spouts.
• Push the Rotary Dial. The S9 OT will push hot water through
the Dual Coffee Spouts and then return to COFFEE READY .
15.2 REMOVING STONES FROM THE BURR GRINDER
If the burr grinder is blocked, proceed as follows:
• Turn off the machine by pushing the ON/OFF button (Fig. 2,B).
Wait until the machine has shut down completely.
• Turn the main power switch off (Fig 1b).
• Open the bean container lid and remove all beans (scoop out
beans or use a hand-held vacuum cleaner).
• Remove the screw in the bean container (Fig. 23) and
push the grinder shield upwards (Fig. 24) Do not try to
remove the shield completely.
• If any beans remain, remove them.
• Attach the burr grinder release tool (in Welcome Pack) to the
upper burr (Fig. 25).
• If you cannot find this tool call 1-800-220-5701 and we will
send the tool to you free of charge.
• Turn the tool counter-clockwise slowly until the stone
becomes loose.
Attention: Do not try to turn the tool clockwise.
• Fold the shield down and replace the screw.
• Turn machine on and test the grinder without beans to see
if the blockage has disappeared.
15.3 GENERAL CLEANING INSTRUCTIONS
Never use abrasive materials or chemicals to clean the
machine.
• Clean the housing with a soft, damp cloth.
• Rinse water tank daily and fill with fresh cold water.
15.4 EMPTYING THE SYSTEM BEFORE TRANSPORT
This procedure is necessary to prevent water and frost damage
in case you intend to transport the machine.
COFFEE READY
• Place a container under the Cappuccino system and the Hot
Water Spout.
• Turn the machine off. The main power switch is still on.
• Press and hold the Rinse button until the display shows
SYSTEM EMPTYING
• A small amount of water is dispensed. When the process is
completed the machine turns itself off.
The next time the machine is turned on, the display shows
FILL SYSTEM/PRESS STEAM (chapter 6c).
15.5 CLEANING THE FROTHXPRESS
After frothing a few drops of milk remain inside the frothXpress.
The S9 OT displays
RINSE CAPPUCCINO . Follow the instruc-
tions in chapter 10g.
31.