Start playback, Activate repeat playback, Stop playback – JVC HR-J635EA User Manual
Page 14: Remove power supply, Set a/b code switch, Re-supply power, Turn the recorder on, Repeat playback, Soundtrack selection, Playback (cont.) remote a/b code switching
14
EN
Your video recorder can automatically play back the whole tape
20 times repeatedly.
Repeat Playback
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
● "PLAY" on the display panel blinks slowly.
● The tape plays 20 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW , FF or PAUSE also stops Repeat Playback.
Soundtrack Selection
Your video recorder is capable of recording three soundtracks (HI-FI L, HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing AUDIO MONITOR (
on the remote control) changes the soundtrack being played back as follows:
NOTES:
●
"L + R" should normally be selected. In this mode, Hi-Fi stereo tapes are played back in stereo, and the NORM track is played back
automatically for tapes with only normal audio.
●
For instructions on recording stereo and bilingual programmes, refer to page 17.
●
"O.S.D." must be set to "ON" or the on-screen displays will not appear (
੬
pg. 5).
TRACK
Recorder's Front Panel
On-Screen Display
USE
L + R
HI FI
For Hi-Fi stereo tapes
L
R
L
HI FI
For main audio of Bilingual tapes
L
R
HI FI
For sub audio of Bilingual tapes
R
NORM
NORM
For audio-dubbed tapes
L + R + NORM
HI FI
For audio-dubbed tapes
NORM
PLAYBACK (cont.)
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control’s A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
REMOVE POWER SUPPLY
1
Unplug the mains power cord from the mains outlet.
SET A/B CODE SWITCH
2
Set to B.
RE-SUPPLY POWER
3
Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4
Press OPERATE on the remote control. The recorder
will now only respond to B code signals.
NOTE:
Some TV sets may malfunction in response to the B mode. If
this happens, switch back to the A mode.