Sony DSR-2000A - Manual (Page 19)

Chapter 1
Overview
Chapter 1 Overview
19
4 RESET button
To reset a time counter value (COUNTER) shown in
the time counter display, press this button.
Resetting the COUNTER value erases all edit points.
This button is also used for setting time code and user
bit values and in setup menu operations.
5 PB/EE (playback/E-E) button
To select E-E mode input signals for the video/audio
signals output during fast forward, rewind, still, and
standby, press this button, turning it on.
Either one of this button and the PB button is always
lit.
6 PB (playback) button
To select playback signals for the video/audio signals
output during fast forward, rewind, still, and standby,
press this button, turning it on.
Either one of this button and the PB/EE button is
always lit.
7 HOLD button
To stop updating of the time code or user bit value in
the time counter display (that is, to hold the display),
press this button, turning it on. To set a time code or
user bit value, first press this button to hold the value.
8 COUNTER SEL (select) button
This switches the value shown in the time counter
display in the following sequence: COUNTER, TC, U-
BIT.
Time counter display selection
a) The selection of TC or VITC is made by the TC SELECT
switch on the subsidiary control panel.
Selection Value displayed
COUNTER Tape running time (hours, minutes,
seconds, frames)
TC Playback time code read by the internal
time code reader or time code being
recorded.
a)
U-BIT User bit value inserted in the playback time
code or time code being recorded.
a)
2 Display section
1 Recording/playback format indicators
2 ClipLink indicator
3 VITC indicator
4 Time data type indicators 5 Time counter display
6 REC INHIBIT indicator
7 Cassette memory indicator
8 KEY INHIBIT indicator
9 SERVO indicator
!º CHANNEL CONDITION indicator
!¡Tape end alarm indicator
!™ SHUTTLE/JOG indicators
!£ NOT EDITABLE indicator