Woodstock W1812 - Manual (Page 22)

-19-
N(/()Fne\i jDXelXc D]^%j`eZ\*&'0
FG
<
I
8
K@FEJ
@ejkXcc`e^GcXe`e^Be`m\j
Kf`ejkXcck_\gcXe`e^be`m\j#[fk_\j\jk\gj1
(. DISCONNECT THE PLANER/MOULDER FROM POWER!
). Pull the pin shown in =`^li\20, and remove the chip
deflector.
*. Put on heavy leather gloves, and use a 14mm wrench
to remove the knife bolts, washers, and any knives (if
installed).
+. Remove any dust, wood chips, or pitch from the
cutterhead where the planing knife will seat.
,. Place the new planer blade against the cutterhead
lip with the beveled side of the blade facing up, as
shown in
=`^li\21.
-. Line up the holes in the planer blade and the
cutterhead, and install a 3 ⁄
8
"-16 x 1" knife bolt and 3 ⁄
8
"
flat washer in each of the upper hole positions shown
in
=`^li\21. Make sure to keep the planer blade
seated against the cutterhead lip while tightening the
bolts.
.. Visually inspect to make sure that the planer blade
did not move away from the cutterhead lip ( =`^li\
22) during the tightening process. If so, reinstall the
blade until it is correctly seated.
/. Rotate the cutterhead and install the other planer
blade.
0. Set the depth stop (=`^li\19) to maintain planer
blade to table clearance.
10. Adjust the feed rollers and spring tension as outlined
in Feed Roller Height and Spring Tension on Page
21.
N<8I k_`Zb ^cfm\j Xe[ lj\
\oki\d\ ZXlk`fe n_\e nfib$
`e^ e\Xi Zlkk`e^ jli]XZ\j. GcXe\i
be`m\j Xi\ [Xe^\ifljcp j_Xig
=X`cli\ kf \o\iZ`j\ ZXi\ n_`c\
nfib`e^ e\Xi be`m\j Zflc[ i\jlck
`ej\m\i\`ealip.
=`^li\21.Installing a planer blade.
=`^li\20.Removing the chip deflector.
Upper Hole Bevel Side
Up
=`^li\22.Planer knives installed.
Lip
Chip
Deflector