Smeg C92GMX User Manual
Smeg Hobs
Advertising
Table of contents
Document Outline
- 1. PRECAUTIONS FOR USE
- 2. RECYCLING INSTRUCTIONS - OUR ENVIRONMENT POLICY
- 3. SAFETY PRECAUTIONS
- 4. INTENDED USE
- 5. GETTING TO KNOW YOUR COOKER
- 6. BEFORE INSTALLATION
- 7. DESCRIPTION OF FRONT PANEL CONTROLS
- 8. USING THE HOB
- 9. USING THE OVEN
- 10. AVAILABLE ACCESSORIES
- 11. ELECTRONIC PROGRAMMER
- 12. CLEANING AND MAINTENANCE
- 13. EXTRAORDINARY MAINTENANCE
- 14. INSTALLING THE APPLIANCE
- 14.1 Electrical connection
- 14.2 Ventilation requirements
- 1 All rooms require an opening window or equivalent, and some rooms will require a permanent vent as well.
- 2 For room volumes up to 5 m3 an air vent of 100 cm2 is required.
- 3 If the room has a door that opens directly to the outside, and the room exceeds 1 m3 no air vent is required.
- 4 For room volumes between 5 m3 and 10 m3 an air vent of 50 cm2 is required.
- 5 If there are other fuel burning appliances in the same room B.S. 5440 part 2 1989 should be consulted to determine the air vent requirements.
- 6 This appliance must not be installed in a bed sitting room of less than 20 m3 or in a bathroom or shower room.
- 14.3 Connecting to natural and LPG gas (Please see connection diagram)
- 15. ADAPTATION TO DIFFERENT TYPES OF GAS
- 15.1 Replacement of nozzles on the hob
- 7 Extract the grids and remove all the caps and flame-spreader crowns;
- 8 Unscrew the burner nozzles with a 7 mm socket wrench;
- 9 Replace the nozzles according to the type of gas to be used and the description in paragraph "15.2 Burner and nozzle characteristics table";
- 10 Replace the burners in the correct position.
- 15.2 Burner and nozzle characteristics table
- 15.3 Arrangement of the burners on the hob
- 15.1 Replacement of nozzles on the hob
- 16. FINAL OPERATIONS