SanDisk 5000 2.5" - Manual (Page 17)

360 Herndon Parkway
Suite 1400
Herndon, VA 20170
http://www.rheintech.com
SanDisk Corporation Page 17 of 17
DoC Report
2006137
04/27/07
7 MANUFACTURER’S EQUIPMENT FILE CHECKLIST (PER FCC RULES §2.1075)
This checklist shall be used by the manufacturer to verify the correct filing per FCC 2.1075 Retention of records
for products produced and marketed.
PRODUCT MODEL(s): Records Verified By:
SanDisk SSD SATA 5000 2.5”
A record of the original design drawings and specifications.
A record of all changes that have been made that would affect continued compliance
with the authorized unit (e.g., any changes which would require a Class I or Class II
permissive change).
A record of the procedures used for production inspection and testing (if tests were
performed) to ensure ongoing conformance.
A record of the measurements made on an appropriate (NVLAP-accredited) test site
that demonstrates compliance. The record shall contain:
• (i) The actual date or dates testing was performed;
• (ii) The name of the test laboratory, or individual performing the testing. (The
Commission may request additional information regarding the test site, the test
equipment or the qualifications of the Test laboratory from the client. or individual
performing the tests);
• (iii) A description of how the device was actually tested, identifying the measurement
procedure and test equipment that was used contained in the test report
• (iv) A description of the equipment under test (EUT) and support equipment
connected to, or installed within the EUT
• (v) The identification of the EUT and support equipment by trade name and model
number and, if appropriate, by FCC identifier and serial number;
• (vi) The types and lengths of connecting cables used and how they were arranged
or moved during testing;
• (vii) At least two photographs showing the test set-up for the highest line conducted
emission and showing the test set-up for the highest radiated emission. These
photographs must be focused originals which show enough detail to confirm other
information contained in the test report;
• (viii) A description of any modifications made to the EUT Client, or individual to
achieve compliance with the regulations;
• (ix) All of the data required to show compliance with the appropriate regulations;
• (x) The signature of the individual responsible for testing the product along with the
name and signature of an official of the responsible party, as designated in §2.909;
• (xi) A copy of the compliance information (i.e., the DoC), as described in §2.1077,
required to be provided with the equipment as follows:
(a) Identification of the product (name and model number);
(b) The unique model name and FCC DoC logo information as specified in
§15.19(b)(1) and §15.105, that the product complies with Part 15 of the FCC
Rules;
(c) Identification, by name, and address of the responsible party.