Sony WALKMAN MZ-R50 - Manual (Page 32)

32
-EN
Messages
If the following error messages flash in the display window, check the chart below.
Error message
BLANK DISC
DISC ERR
DISC FULL
Data Save
Toc Edit
BUSY
NAME FULL
Hi DC in
HOLD
LOW BATT
MEM OVER
Meaning/Remedy
•An MD with no recording on it is inserted.
b Insert a recorded MD.
•The recorder cannot read the disc (it's scratched or dirty).
b Reinsert or replace the disc.
•There is no more space to record on the disc (less than 12
seconds available).
b Replace the disc.
•The MD player is recording information (sounds) from the
memory to the disk.
b Wait until this process is completed. Do not expose the
player to any physical shock, nor disrupt power supply.
•The MD player is recording information (track start and end
position) from the memory to the disk.
b Wait until this process is completed. Do not expose the
player to physical shock, nor disrupt power supply.
•You tried to operate the recorder while it was accessing the
recorded data.
b Wait until the message goes out (in rare cases, it may take
2–3 minutes).
•You tried to enter more than 200 characters for a track or disc
name or the total characters entered in an MD is more than
1700.
b Enter the characters within the limit.
•Voltage of the power supply is too high (The supplied AC
power adaptor or the recommended car battery cord is not
used).
b Use the supplied AC power adaptor or the recommended
car battery cord.
•The recorder is locked.
b Slide HOLD against the arrow to unlock the recorder
(page 20).
•Batteries are weak.
b Charge the rechargeable battery or replace the dry
batteries (pages 25, 26).
•You tried to record when there is no indication in the display,
with the recorder placed where it receives continuous
vibration.
b Put the recorder on a stable place, and start recording
again.