Woodstock REBEL W2000 - Manual (Page 9)

8 – W2000 Rebel ®
The safety guard system consists of a clear plastic
guard and arm which have been assembled at the fac-
tory. There is also a height adjustment bar, mounting
bracket with lock knob and bolt and washer. The clear
plastic guard has been designed to fit over the router bit
during operation and can be connected to a 3" flex-
hose for dust collection purposes.
S Stteep p 1 1 - Mount the safety guard mounting bracket to
the back of The Rebel ® table with the two 1 ⁄
4
"-
28 x 1" socket head cap screws provided.
F
Fiig gu urree 6 6..
C C.. S Saaffeetty y G Gu uaarrd d
F Fiig gu urree 6 6.. Mounting safety guard bracket.
The miter gauge has been pre-assembled at the factory,
except for the handle. The handle greatly aids in miter
gauge control. To assemble the handle:
Thread the handle into the hole located on top of the
miter gauge body and tighten down. F
Fiig gu urree 8 8..
D D.. M Miitteerr G Gaau ug gee
F Fiig gu urree 8 8.. Attaching the miter gauge handle.
F Fiig gu urree 7 7.. Safety guard installed.
S Stteep p 2 2 - Insert the height adjustment bar into the
mounting bracket so the threaded hole is fac-
ing up. Tighten the lock knob to secure the
height adjustment bar.
S Stteep p 3 3 - Slide the 5 ⁄
16
"-18 x 3 ⁄
4
" hex head bolt through
the 5 ⁄
16
" flat washer and loosely thread into the
hole on top of the height adjustment bar.
S Stteep p 4 4 - Slide the slotted end of the safety guard arm
under the washer and tighten the hex head
bolt. F
Fiig gu urree 7 7.