Spirit XE295 - Manual (Page 11)

7
Elliptical Trainer
XE295
1. Untie the twist tie that holds each bushing (22) to the Connecting Arm end. Align the hole in the end of the
Connecting Arms (L & R) (8 & 9) with the hole in the bracket of the Swing Arms (L) and (R), (10 & 11). The
Connecting Arm ends should be inside of the Swing Arm (L) and (R), (10 & 11) brackets. Slide a Hex Head
Bolt (104) through each Swing Arm (L) and (R), (10 &11) bracket and each Connecting Arm end.
2. Slide a Flat Washer (80) onto each bolt, then fasten the arms together by tightening a Nyloc Nut (71) to each
bolt using the wrenches provided (109 & 106) wrenches.
HARDWARE
STEP 3: Connecting Arm
#80.ƒ5/16” x 20 x1.5T
Flat Washer
(2 pcs)
#71.ƒ5/16”
Nyloc Nut
(2 pcs)
#104.ƒ5/16” x 1-1/4”
Hex Head Bolt
( 2 Pcs)