Speco Technologies P120FACD/P240FACD - Manual (Page 18)

PUBLIC ADDRESS AMPLIFIER
16 P120FACD/P240FACD
1. MIC PRIORITY (CH1,CH2)
Turn the volume, to choose ‘SET MIC1(MIC2) MUTE LVL’, Press ENTER, .
Choose MIN, MID, or MAX with the volume , Press ENTER, .
- MIN : Attenuate level of the other channels by -6dB.
- MID : Attenuate level of the other channels by -12dB.
- MAX: Mute the other channels.
To use the MIC Priority function, press the MIC Priority Switch on the rear panel
2. TEL-IN LEVEL
You can adjust the TEL-IN level. Turn the volume, to choose 'TEL-IN LEVEL', Press ENTER, .
(VOL: 0(MIN) ~ 31(MAX), DEFAULT: MAX)
3. CHIME LEVEL
You can adjust the chime level. Turn the volume, to choose 'CHIME LEVEL', Press ENTER, .
Adjust the level with the volume .
(VOL: 0(MIN) ~ 31(MAX), DEFAULT: MAX)
4. BEEP SOUND
Beep sound when you press a button on the front panel.
You can set it on or off. Turn the volume,
to choose 'BEEP SOUND', Press ENTER, .
Choose ON or OFF, Press ENTER, .
- ON: Beep sound.
- OFF: Beep does not sound.
5. IR REMOTE CONTROL
You can set the optional IR Remote Control function on or off. Select IR REMOCON from the menu and press
ENTER . Choose ON or OFF and press ENTER again .
- ON: Enable the optional IR Remote Control function
- OFF: Disable the optional IR Remote Control function
6. KEY LOCK FUNCTION
All the key inputs except Power button can be locked by the KEY LOCK function.
Turn the volume,
to choose 'KEY LOCK', Press ENTER, . Choose Lock or Unlock, Press ENTER, .
7. EM BROADCASTING: VOLUME SETUP FUNCTION
The is to set up ‘output volume level’ of an amplifier in case of EM broadcasting. At an initial setup, after
select EM broadcasting sourcce from no. 8 and give an input to EM terminal. And then, adjust an appropriate
volume with ®Í volume controller. (VOL: 50~70, DEFAULT: 60)
8. SYSTEM INFORMATION
Choose SYSTEM INFO and press ‘ENTER’, . You can check the current firmware version.
If you do not press any key for 10seconds, you will exit the SETUP mode.