Smeg ST147 - Manual (Page 18)

User instructions
17
•
Do not use table salt as it contains insoluble substances which,
over time, may damage the water softening system.
•
When necessary, refill the regenerating salt container before
starting the washing program. In this way, the excess saline
solution will be immediately removed by the water; the prolonged
presence of salt water inside the tank may lead to corrosion.
Be careful not to confuse the salt and detergent packages; adding
detergent to the salt container will damage the water softening system.
ADJUSTING THE WATER SOFTENING SYSTEM
NOTA: for the setting below to be possible, a washing program other
than the soak program must be set.
Press the
PROGRAM DELAY button (10) and keep it pressed until the
preset value appears followed by a full stop (normally
3.). Release the
button then press it again in succession to display the value required,
referring to the table.
The
6 setting levels available will appear in this order:
3., 4., 5., 0., 1., 2..
When the value required appears on the diplay, release the button; after
5 seconds the system automatically returns to setting of the program
delay, and the setting will be made with the chosen value.
N.B.: the display shows the water hardness setting and the program
delay. The dot (
.) after the number indicates that the water hardness
setting is being displayed. If the dot (
.) does not appear, the program
delay is being displayed.