SECO-LARM USA NVD Bullet Cameras EV-1626-PWGQ - Manual (Page 3)

NVD Bullet Cameras
SECO-LARM U.S.A., Inc. 3 3 SECO-LARM U.S.A., Inc.
33 3
1. Please read this manual carefully and keep it for
future reference.
2. Use the camera within given temperature and
electrical limits.
3. Do not aim the LEDs directly at the eyes when the
LEDs are on.
4. Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
5. Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong
electrical signals.
1
6. Do not open or disassemble the camera. There are
no field-serviceable parts inside.
7. Do not drop the camera or subject it to
strong vibrations.
1 Note: Many video monitors produce strong
electromagnetic fields close to the display CRT,
especially when the monitor is turned on or
during de-Gaussing, which occurs automatically
with many monitors when turning on.
1. Run a 12VDC or 24VAC power supply wire and a
video cable with a male BNC connector through the
wall to where the camera is to be mounted. 2
2. Temporarily connect the camera to the power
supply. Do not cut DC jack or female BNC
connector as warranty will be voided. If needed,
use the included SECO-LARM DC plug with
terminal block.
3. Remove service cover and connect included service
monitor port connector to service monitor port.
4. Connect the service monitor port connector’s BNC to
a test monitor.
5. While watching the monitor, hold the camera against
the wall or ceiling by hand where it is to be mounted,
then turn the camera until it is certain that this
mounting location is correct. Use a pencil to mark
the location of the four screw holes in the mounting
plate.
6. Mount the mounting plate to the wall or ceiling using
the four included mounting screws. If the
wall is made of drywall, brick, or similar material,
it may be necessary to use screw anchors
(not included).
7. Mount the camera base to the mounting plate using
the four included hex screws.
8. Adjust the camera angle.
9. Adjust zoom and focus. Then use the OSD control
joystick to adjust camera settings. (See OSD
manual).
10. Disconnect the power supply and service
monitor connector.
11. Put the sunshield on the camera.
12. Do a final test of the video camera and monitor.
2 Note: The base also allows for surface running of the
wires. However, for a cleaner, more secure
installation, run the wires through the wall.
Installation:
Before Starting:
Overview:
A. Camera
B. Adjustable sunshield
C. Mounting plate
D. Camera base
E. Hex screws
F. Mounting screws
G. Focus
H. Zoom
I. Service cover
J. Female BNC
connector
(video out)
K. DC jack
L. DC plug with
terminal block
M. Service monitor port,
OSD joystick
A
B
C
D
E
F
H
G
I, M
OSD joystick
Connect service
monitor port connector
to service monitor port
Important:
Do not cut DC jack (K) or
female BNC connector (J) as
warranty will be voided.
K
J
L