Samsung MAX-VS530 - Manual (Page 10)

GB
10
Your system is equipped with a clock which allows you to turn your
system on and off automatically. You should set the clock:
When you purchase the mini-compact system
After a power failure
After unplugging the unit
Remember to reset the time when the clock changes from
winter to summer time and vice verse.
For each step, you have a few seconds to set the required options.
If you exceed this time, you must start again.
Switch the system on by pressing Standby/on.
Press Timer/Clock twice.
Result:
CLOCK is displayed.
Press Enter.
Result: The hour flashes.
To... Press the...
Increase the hours
Decrease the hours
When the correct hour is displayed, press Enter.
Result: The minutes flash.
To... Press the...
Increase the minutes
Decrease the minutes
When the correct time is displayed, press Enter.
Result: The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing Timer/Clock once.
All functions available on the system can be viewed on the
display and the display's brightness can be switched between
"on" and "off".
Press the Demo/Dimmer button.
Result: All functions available on the system appear on the front
panel display.
Each of these are explained in detail in this guide. Please refer to
the relevant section.
Press the Demo/Dimmer button again.
Result: The Dimmer function is selected and the display darkens.
Press the Demo/Dimmer button once again to brighten the front
panel display.
A display brightness control can only be performed while the
system power is on.
Setting the Clock
1
2
3
4
5
6
7
2
3
1
Demo/Dimmer Function
1
3,5,7
2
4,6 4,6
MAX-VS530 GB-1~18 10/17/03 16:03 Page 10