Sound Stream VHD-9BK - Manual (Page 6)

How To Control The Monitor
6
AV2 SD USB
1. Power On/Off
<Unit>
To power on the unit, press POWER button on the monitor;
or press POWER button on the remote control.
AV2 SD USB
To power the off unit, press MPWR or PWR on the monitor;
or press POWER button on the remote control.
2. Mode Change
MENU MODE MPWR
AV2 SD USB AV2 SD USB
PLAY
MENU
STOP
PREV
NEXT PWR
VOL-
MODE
VOL +
(1) Press any place on the monitor screen with your finger softly ,and you will see the MODE button on the monitor .
(2) Press the MODE button to change an Input Mode.(AV1-AV2-DVD)
AV2 SD USB
PLAY
MENU
STOP
PREV
NEXT PWR
VOL-
MODE
VOL +
AV2 SD USB
MODE MENU MPWR
1
2
Installation
35
Product installed
AV2
1. Remove the existing headrest from the seat.
2. Adjust the posts of the new headrest to fit the holes in the seat where the
headrest will be installed. The post can be moved together or apart
grasp one post in each hand, move the posts in opposing directions
(like they were walking) while pushing them toward each other or away
from each other.
3. Insert the cable in the proper hole. Insert the posts into the holes in the
seat and carefully work the headrest into position. Make sure the cable
is not pinched.
4. Run the cable down the seat and out to the location of the video source
unit (such as a DVD player).
5. See the picture on the right and you can adjust
the distance between the tubes to required
space(pole width adjustments 4
~ 8.2 . )
How to use the Adapter tubes
Since the spacing of the mounting holes
can vary on different veicles we supply
two adapter tubes. Use these tubes when
the headrest mounting holes in your seat
are too large for the posts of the headrest
monitor.
AV2 SD USB
SD USB
AV2 SD USB
MENU MODE MPWR