Swann PPW-250 - Manual (Page 2)

H
General Installation Notes and Tips
1. Test the camera signal before permanently installing the cameras.
2. Using battery power is only recommended for testing purposes as the cameras do require constant power to operate.
3. IR or night vision will reflect off of glass or windows and overexpose the picture. Try placing cameras in direct line of
sight of your subject.
4. Never aim the camera directly at the sun as this can permanently damage the lens.
5. Never submerge the camera in water. Some shelter is recommended such as an awning or eave.
Wireless Camera Positioning
Achieving the highest quality wireless signal G
G F E
Wireless Internet
Cordless Phones/Mobiles
Some Electronic Devices
If possible turn off or keep
the camera and receiver
away from wireless devices
Some wireless devices can
be set to different frequencies.
Consult the manufacturer’s
manual for details
A clear line of sight with little wireless interference
will always give you the strongest picture
Cable for wireless connections only
To Power Supply
To DVR/Monitor
To Power Supply
Cable for wired connection
Walls and floors can also limit range and image results. Place the receiver in a location that
is relatively close to the camera’s position
OR
Setting up Wireless or Wired options
Note: Wireless and electronic devices such as these can interfere with camera
transmission if they are within the cameras range.
Cable for wired connection
www.swannsecurity.com
Swann Communications • Toll Free Technical Support: USA - 1-800-627-2799, 1-877-274-3695, Australia - 1300 13 8324 • Email: [email protected]
.com
Wireless / Wired Security Camera
PPW-250 Easy Setup Guide