Sherwood TX-5090C - Manual (Page 9)

Operations
9
ENGLISH
LISTENING TO RADIO BROADCASTS
LISTENING TO FM STEREO BROADCASTS
Manual tuning
Auto tuning
Each time the AM button is pressed, the band changes
as follows;
Example) When selecting the FM band.
MW LW
Each time the POWER switch is pressed, this unit is
turned on or off.
This unit will now search until a station of sufficient
strength has been found.
The display shows the tuned frequency and “TUNED”.
If the station found is not the desired one, simply repeat
this operation.
Weak stations are skipped during auto tuning.
While listening to FM brodcasts, select the desired
FM mode.
Each time this button is pressed, the FM mode changes
as follow;
When FM stereo broadcasts are poor because of weak
brocasts signals, select the FM mono to reduce the
noise, then FM broadcasts are reproduced in monaural
sound.
Manual tuning is useful when you already know the
frequency of the desired station.
Perform the steps 1~2 in “Auto tuning” porocedure
and press the TUNING UP(
) or DOWN( ) button
repeatedly until the desired frequency has been
reached.
Press the TUNING UP( ) or DOWN( )
button for more than 0.5 second.
3
Turn the power on.
1
Select the desired band.
2
MHz
STEREO mode : “ST” lights up
MONO mode : “ST” goes off