Stoelting 513588R1 - Manual (Page 19)

11
3.7 CLEANING THE FREEZER
NOTE
The frequency of cleaning the freezer and freezer
parts must comply with local health regulations.
After the mix has been removed from the freezer, the
freezer must be cleaned. To clean the freezer, refer to the
following steps:
A. Close the spigot and fill the hopper with 2 gallons (7.5
liters) of cold tap water.
B. Place the OFF-ON switch in the ON position while
pushing the CLEAN switch to rotate the auger.
C. Allow the water to agitate for approximately 5 minutes.
NOTE
If freezer is left in CLEAN for more than 20 minutes,
it will go to error.
D. Open the spigot to drain the water. Remember to place
a bucket or container under the spigot to catch the
water. When the water has drained, turn the OFF-ON
switch to the OFF position. Allow the freezer barrel to
drain completely.
E. Repeat Steps A through D using a mild detergent
solution.
3.8 DISASSEMBLY OF FREEZER PARTS
CAUTION
PLACE THE OFF-ON TOGGLE SWITCH IN THE
OFF POSITION BEFORE DISASSEMBLING FOR
CLEANING OR SERVICING.
Inspection for worn or broken parts should be made at
every disassembly of the freezer for cleaning or other
purposes. All worn or broken parts should be replaced to
ensure safety to both the operator and the customer and
to maintain good freezer performance and a quality prod-
uct. Two normal wear areas are the auger flights and front
auger support (Fig.18). Frequency of cleaning must com-
ply with the local health regulations.
Figure 18. Auger Flight Wear and Front Auger
Support Bushing Wear
To disassemble the freezer, refer to the following steps:
A. Remove hopper cover and drain tray (Fig. 19).
B. Remove the mix inlet regulator from the hopper by
pulling straight up.
C. Remove the front door by turning off the circular knobs
and then pulling the front door off the studs.
Figure 20. Front Door Disassembly
E. Remove the front auger support and bushing (Fig. 21).
Figure 21. Removing Auger Support
Figure 19. Removing Front Door
D. Remove the rosette, then remove the spigot body from
the front door by pushing the spigot body through
the bottom of the front door (Fig. 20).
Hopper Cover
Drain Tray