Sanyo VCC-6570P - Manual (Page 16)

SETTINGS
External sync adjustment (VBS)
1 Connect the VBS signal output for the other camera to the VBS
IN connector at the rear of this camera.
2 If the signals are not synchronized, change the sub-carrier (SC-P1)
switches as follows.
Setting 9-pin 10-pin
Default OFF (down) OFF
Set to 90˚ counterclockwise OFF ON (up)
Set to 180˚ counterclockwise ON OFF
Set to 270˚ counterclockwise ON ON
Note:
• The sub-carrier switches let you make broad adjustments to the
sub-carrier phase. If finer adjustments are required, contact the
place of purchase.
• The type and length of the cable which is connected to the VBS
connector may cause the horizontal synchronization being out of
phase. If this happens, adjust VR304 (H-P: horizontal sync).
Lens iris adjustment
If using a DC type auto-iris lens, you will need to set the LEVEL
(VR301) volume when shooting in the conditions described below.
L (counterclockwise): To decrease the contrast
H (clockwise): To increase the contrast
• If shooting simultaneously in a dark room and through a bright
window.
• If the subject background is extremely bright or dark.
• If the brightness of the picture on the monitor is not correct.
10 9
VR304
H-P
VR301
LEVEL
L53T5/XE GB 2001, 7, 26
English
15