SATO CL408e - Manual (Page 100)

PCMCIA MEMORY CARDS ALL MODELS
Description
The Memory Card Option provides the connectors and interface board for one
PCMCIA memory card slot. The PCMCIA memory is selected for use via the
<ESC>CC Memory Area Select command. It can be used to store fonts, graphic
images and forms.
Type SRAM or Flash
Applicable Specifications PCMCIA Version 2.1 (JEIDA Version 4.1)
Size Up to 4MB SRAM or 16MB Flash
Connector Pins 68
Battery Approximately two years (manufacturer dependent)
Write Protect Yes
Low Battery Detect Yes
Installation
Instructions for installing the Memory Card Option are included with the installation
kit.
Error Handling
Memory Card error conditions are indicated to the operator using a combination of
the ERROR LED on the front panel, the LCD display and the audible indicator.
ERROR DESCRIPTION INDICATION REMEDY
Low Battery - Low battery
condition is detected when
printer is powered on. ERROR LED: Blinking
Audible Beep: 1 long
Display: Card Low Battery
Depress LINE key to print
Card Status.
Replace Memory Card
battery. Note that all data
will be lost when the battery
is removed.
Card R/W Error
1. No card is inserted.
2. Card is write protected.
3. Invalid store/recall
number.
4. Card has not been
initialized. ERROR LED: On
Audible Beep: 1 long
Display: Card R/W Error
Printer must be powered off
to reset.
1. Insert card into selected
slot.
2. Remove write protect tab.
3. Correct program
4. Initialize card with BJF
command
Warning
1. Duplicate number.
2. Data not in print area.
3. Data overflows card
memory. Audible Beep: 1 short
Display: None
Printer will ignore invalid
commands.
1. Correct program.
2. Correct program.
3. Use card with more
capacity.
SATO CL Series “e” Printers PN 9001074 Rev. B Page A-7
Appendix A: Optional Features