Sony SLV-EZ11AZ - Manual (Page 22)

Getting Started
22
Disabling unwanted programme positions
After presetting channels, you can disable unused programme positions. The
disabled positions will be skipped later when you press the PROG +/–
buttons. (For SLV-EZ44AZ/EZ22AZ only) You can also disable unwanted
programme positions using the SET UP CH AND G-CODE menu (page 28).
1
Press MENU, then press M/m to move the cursor (B) to TUNER
PRESET and press OK.
2
Press PROG +/– to select the programme position you want to skip.
3
Press M/m/</, to move the cursor (B) to ADD/ERASE, then select
ERASE.
4
Press OK.
If the picture is not clear
Normally, the Auto Fine Tuning (AFT) function automatically tunes in
channels clearly. If, however, the picture is not clear, you may also use the
manual tuning function.
1
Press PROG +/– to select the programme number for which you cannot
obtain a clear picture.
2
Press MENU, then select TUNER PRESET and press OK.
3
Select FINE TUNING.
The fine tuning meter appears.
4
Press </, to get a clearer picture, then press OK.
Note that the AFT (Auto Fine Tuning) setting switches to OFF.
Notes
• The menu disappears automatically if you do not proceed for more than a few
minutes.
• The channel numbers besides CHANNEL SET may not be the same as those in your
area. This is because this VCR’s channel search system is based on the fixed TV
system that has the widest channel coverage. If necessary, apply your local channel
numbers to the programme positions (see “Changing programme positions” on
page 26).
Selected programme position
Presetting channels (continued)
PROG14 TUNER PRESET
NORMAL / CATV
AUTO PRESET
CHANNEL SET
AFT
ADD / ERASE
FINE TUNING
NORM
ON
•
•
CATV
OFF
ADD • ERASE
35
SET : [ ]
COUNTRY AUS • NZ