Speco Technologies 4 - Manual (Page 94)

94
APPENDIX: E-SATA CONNECTION
Please read the following instructions before using the E-SATA port.
Failure to do so may cause serious damage to the recorded video.
SPECO is not responsible for data loss caused by improper usage.

Use ONLY a new HDD or a HDD that is pre-formatted on a PC.

Turn off the DVR before plugging the E-SATA HDD.

DO NOT disconnect the E-SATA port while the DVR power is on.

The purpose of the E-SATA port is to extend recording capacity.

Once connected, DO NOT remove or disconnect the E-SATA port from the DVR.

The E-SATA port does not support the hot swappable function.