Seiko Group UB-R02 - Manual

1
UB-R02 User’s Manual
Copyright © Seiko Epson Corporation 2004
Printed in China 2004.01
Introduction
The UB-R02 is an interface board on which is installed an IEEE 802.11b Radio
Frequency (RF) module for EPSON
® TM printers.
This manual provides instructions, including a simple setup for operators of
POS systems in which the UB-R02 is installed so that the operators can use the
UB-R02 safely and correctly.
Key to Symbol
The symbol in this manual is identified by its level of importance, as defined
below. Read the following carefully before handling the product.
Note:
Notes have important information and useful tips on the operation of your equipment.
Features and Functions
❏ 64/128-bit WEP
❏ Protocols: TCP, UDP, ICMP, IP, LP/LPR (for APD), TCP socket port (for
OPOS)
❏ Transfer rate: up to 11 Mbps, depending on operating environment
❏ OPOS, APD support
Part Names
The following view shows the part names of the UB-R02.
Note: This photograph shows the TM-T88III printer with the UB-R02 installed.
DIP Switches
When using this interface board, the interface of the TM printer must be
selected as “parallel” with the appropriate settings. Set the reset signal for pin
31 to “enable,” if you are using a TM printer that has this setting. Refer to the
manual for each TM printer for details.
Drawer kick-out
connector Push button Power supply
connector
410462701