Drivers installation guide 39, Sco unix 5.0 – SOYO 6KB82440 User Manual
Page 43
Drivers Installation Guide
39
4)
From root directory, type the following commands:
mkdir/inst
cd /inst
tar xvf /tmp/trisco.tar.
(Note: there is a period at the end of the last command.)
5)
Now, insert a blank diskette into the floppy drive A and type:
tar cvf /dev/<your floppy drive A device name>.
(Note: there is a period at the end of the last command.)
Your floppy drive A device name could be:
¥
rfd096ds15,5.25 DSHD
¥
rfd0135ds18 3.5 DSHD
¥
rfd048ds9 5.25 DSDD
¥
rfd0135ds9 3.5 DSDD
Now you have already made an installation diskette for the device
driver.
Start the installation by typing: custom.
6)
Select the ÒInstallÓ operation and then follow the guided steps.
When prompted ÒDo you want to set the device configuration (y/n)Ó,
answer ÒnÓ.
7)
Reboot your SCO UNIX system.
SCO UNIX 5.0
1)
Install SCO UNIX 5.0 using the default SCO IDE driver.
2)
Reboot your SCO UNIX system
3)
Insert Triones supplied diskette into the 3.5 inch floppy drive of
your system. Use doscp command to copy the file TRISCO.TAR to
your /tmp directory. for example, if you are using floppy drive A,
type: doscp a:/scounix/trisco5.tar/tmp/trisco5.tar