SOYO 5EAS5 P55C - Manual (Page 19)

Hardware Setup
15
Multi I/O Port Addresses
Default settings for multi I/O port addresses are shown in the table below.
Port I/O Address IRQ Status
LPT1* 378H 7 ECP + EPP
COM1 3F8H 4
COM2 2F8H 3
If default I/O port addresses conflict with other I/O cards (e.g. sound cards
or I/O cards ) , you must adjust one of the I/O addresses to avoid address
conflict. (You can adjust these I/O addresses from the BIOS)
Note: Some sound cards have a default IRQ setting for IRQ7, which
may conflict with printing functions. If this occurs do not use sound
card functions at the same time you print.
Connectors
Attach the mainboard to case devices via connectors on the mainboard. Refer to
Figure 1-1 for connector locations and connector pin positions.
COM1, COM2 – COM1/COM2 Connectors
Attach COM1/COM2 device to these connectors.
FDC Connector
Attach floppy cable to this connector.
J19 – Hardware Reset Control
Attach the reset switch to J19. Closing the Reset switch restarts the system.
J24 – HDD LED Connector
Attach the cable of hard disk drive LED to this connector. The LED lights when
an HDD is active.