SECO-LARM USA Enforcer EV-2240-P3B - Manual (Page 3)

ENFORCER Mini Indoor Dome Camera
SECO-LARM U.S.A., Inc. 3 SECO-LARM U.S.A., Inc.
33 3
1. Please read this manual carefully and keep it
for future reference.
2. Use the camera within given temperature and
electricity limits.
3. Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
4. Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong
electrical signals*
5. Do not drop the camera or subject it to
strong vibrations.
Note: Many video monitors produce strong
electromagnetic fields close to the display
CRT, especially when the monitor is turned
on or during de-gaussing, which occurs
automatically with many monitors when
turned on.
Before Starting:
1. Run hidden cables from the video source and
12VDC power supply to the camera. Do not
cut the DC jack or female BNC connector as
this will void the warranty.
2. Test to make sure the voltage is correct.
Use only 12VDC.
3. Carefully twist the dome from the base.
4. Hold the camera against the wall, ceiling, or
other mounting surface while watching the
monitor to find the best mounting location. Mark
that location with a pencil.
Installation:
5. Mount the mounting base to the wall using
4 mounting screws (not included). If
mounting to drywall or brick, it may be
necessary to use screw anchors (not
included).
6. Adjust the camera angle as needed.
7. Test the video signal.
8. Reattach the dome to the camera.
9. Do a final test of the video camera
and monitor.
Overview:
Dome cover Camera
Mounting screws
(not included)
DC jack
Female BNC connector
DC plug with
terminal block
(not included)