ScyTek Electronics VISIONGUARD 6000 - Manual (Page 9)

VisionGuard 6000 - Page 5
4. Turn off the ignition key.
5. Repeat steps 1-4 to add an additional 2-way transmitter.
System Confirmation
The 2-way transmitter's confirmation feature allows the current vehicle status to be displayed
at any time.
To display system status:
Press and hold Button 4 until the display shows CON.
· The transmitter will beep once.
LCD Transmitter Battery Replacement
Your Galaxy Remote Transmitter uses a 1.5 volt AAA alkaline battery, which will require
replacement in time. Depending on the amount of use, the battery may last up to six months
before it needs replacement. When the battery needs replacing, the system’s operating range
will decrease, the LCD display will show only one of three bars in the battery icon, or the
display and sounds may suddenly stop and start as the battery voltage drops below minimum.
In order to change the battery, first slide the battery door locking pin to the side. Carefully
slide the battery cover downward until it is free. While replacing the battery make sure that
the positive and negative terminals are positioned correctly, then carefully reassemble the
transmitter case.