Sonance Two Zone Connecting Block CB2Z - Manual (Page 4)

Pg 4
Fig. 5: Using a ACB1 for Emitter Expansion
©2002 Sonance. All rights reserved.
33-1891 4.02
CAUTION: Because the Z O N E and C O M M O N jacks on the CB2Z are connected in series, you must
have an emitter(s), a connecting block (with emitters), or other Sonance IR controlled
device plugged into the COMMON jack for the zone emitters to operate! This is true
for the ZONE OUTPUT jacks as well.
M O U N T I N G
The CB2Z can be conveniently mounted to a wall or shelf by using screws or mounted into 3”
SNAPTRACK ® .
CAUTION: Because the Z O N E and C O M M O N jacks on the CB2Z are connected in series, you must
have an emitter(s), a connecting block (with emitters), or other Sonance IR controlled
device plugged into the COMMON jack for the zone emitters to operate! This is true for the
ZONE OUTPUT jack as well.
Fig. 5, below, illustrates an ACB1 driving six emitters for control of six common components. Up
to 10 single or 10 dual emitters may be driven directly from the ACB1 .
SONANCE • 212 Avenida Fabricante • San Clemente, CA 92672
www.sonance.com