ScyTek Electronics 3000Plus Series - Manual (Page 22)

10. Ignore Open Door Report. Bypasses the open zone warning chirps for vehicles equipped with a
residual dome light circuit that remains on for a period of time after closing the door.
11. Horn Chirps with Arm & Disarm / Anti-Carjack with Valet Reset. This dual program branch
activates the horn chirps during Arming and Disarming, and activates one of two Anti-Carjacking
options.
Horn Chirps. When selected, the horn will provide the arm and disarm indications, allowing the siren
installation to be skipped.
Anti-Carjacking w/ Valet Reset. When selected, the Anti-Carjacking feature will be enabled, and
pressing the valet switch will reset the Anti-Carjacking feature when triggered.
Note: Disabling either feature this branch with Button 1 will turn off both features. If either feature
was enabled prior to pressing Button 1, it must be re-enabled or it will remain disabled.
12. Horn Output / Anti-Carjack with Hands-Free Operation.* This dual program branch selects the
operation of the horn output, and activates the second Anti-Carjacking option.
Horn Chirps. When selected, the horn will provide the arm and disarm indications, allowing the siren
installation to be skipped.
Anti-Carjacking w/ Hands-Free Operation.* When selected, the Anti-Carjacking feature will be enabled
for operation with the optional Hand-Free transmitter. Moving the Hands-Free transmitter out of range
of the vehicle will activate the Anti-Carjacking feature, and moving the transmitter back in range will
reset the Anti-Carjacking feature when triggered.
Note: Disabling either feature this branch with Button 1 will turn off both features. If either feature
was enabled prior to pressing Button 1, it must be re-enabled or it will remain disabled.
*Requires the optional Hands-Free transmitter for this Anti-Carjacking feature to operate.
13. Aux 2 Auto Activate with Arm. When selected, the Auxiliary 2 output will activate when the system
is armed. This feature can be used to roll-up windows, close sunroofs, activate accessories, etc.
14. Auxiliary 1 Mode. Selects from momentary, 10 second timed, or latched operation for Auxiliary 1.
Momentary operation provides an output for as long as the transmitter button is pressed.
Timed operation provides an output that turns on for 10 seconds each time the transmitter button is
pressed. If the button is pressed again during the 30 seconds, the output will turn off.
Latched operation provides an output that turns on when the transmitter button is pressed and remains
on until the transmitter button is pressed again.
Note: With the optional ScyNet network interface and Wizard software, any auxiliary function can be
programmed to output for 1 second up to 255 seconds.
15. Auxiliary 2 Mode. Selects from Momentary, Timed, or Latched operation for Auxiliary 2.
16. Auxiliary 3 Mode. Selects from Momentary, Timed, or Latched operation for Auxiliary 3.
17. Disarm with Auxiliary 1. When selected, activating the Auxiliary 1 output (usually used to open the
trunk) will disarm the alarm.
BRANCHES 18-21 ARE RESERVED FOR THE PROGRAMMING OF SCYNET NETWORK ACCESSORIES.
CONNECTION OF OPTIONAL ACCESSORIES IS REQUIRE TO USE ANY OF THESE FEATURES.
Page 18 - Galaxy 3000 Plus