Sony HDW-S2000 - Manual (Page 138)

Chapter 10
Setup Menus
10-30
Chapter 10 Setup Menus
10-4 Items in the Extended Setup Menu
Item number Item name Settings
Menu items in the range 900 to 999, relating to digital processing (Continued)
917 ACTIVE LINE 1080
CONVERT MODE
(Valid only in 59.94i or
29.97PsF mode) Select the conversion mode for the number of active scan lines.
[conv]: Convert the active scan lines from 1035 to 1080, without changing the
aspect ratio.
panel: Convert the active scan lines from 1035 to 1080. Insert the 1035 lines into
1080 lines, then compress horizontally.
Note
This item is valid only when menu item 018 is set to 1080.
934 CROSS COLOR (DC)
(Invalid in 24PsF or
23.98PsF mode) Carry out the down-converter cross color adjustment.
0 to [8] to 15
935 DETAIL GAIN (DC)
(Invalid in 24PsF or
23.98PsF mode) Carry out the down-converter image enhancer adjustment. Adjust the sharpness
of edge emphasis.
0 to [20H] to 7FH
936 LIMITER (DC)
(Invalid in 24PsF or
23.98PsF mode) Carry out the down-converter image enhancer adjustment.
Adjust the maximum detail level added to emphasize the original signal.
0 to [20H] to 3FH
937 CRISP THRESHOLD (DC)
(Invalid in 24PsF or
23.98PsF mode) Carry out the down-converter image enhancer adjustment. Set the threshold
amplitude at which low amplitude signals are not emphasized.
[0] to FH
938 LEVEL DEPEND
THRESHOLD (DC)
(Invalid in 24PsF or
23.98PsF mode) Carry out the down-converter image enhancer adjustment. Set the luminance
range for edge enhancement.
0 to [8] to FH
939 H DETAIL FREQUENCY
(DC) (Invalid in 24PsF or
23.98PsF mode) Carry out the down-converter image enhancer adjustment. Set the central
frequency for edge enhancement.
2.6MHz to 3.4MHz to [3.9MHz] to 4.6MHz
930 DOWN CONVERTER
MODE (Invalid in 24PsF or
23.98PsF mode) Select the down-converter mode.
[crop]: Select the edge-crop mode.
l-box: Select the letter box mode.
squez: Select the squeeze mode.
931 DOWN CONVERTER
LETTER BOX MODE
(Invalid in 24PsF or
23.98PsF mode) Select the aspect ratio of the down-converter output when menu item 930 is set to
l-box.
[16:9]: Set the aspect ratio of the HD-SD converter output to 16:9.
14:9: Set the aspect ratio of the HD-SD converter output to 14:9.
13:9: Set the aspect ratio of the HD-SD converter output to 13:9.
932 H CROP POSITION (DC)
(Invalid in 24PsF or
23.98PsF mode) Adjust the “H-crop” (the horizontal position when cropping in the edge crop mode)
of the up/down converter output when menu item 930 is set to crop.
–120 to [0] to 120
918 SLOW PROCESS MODE Switch the filter for increasing the vertical resolution during slow-motion playback
on or off.
ON: Increase the vertical resolution in slow-motion playback.
[OFF]: Do not increase the vertical resolution in slow-motion playback.
Note
In the case of HDCAM tapes recorded in PsF mode, this item is invalid.
920 SD-SDI H-ANC
CONTROL
(Invalid in 24PsF or
23.98PsF mode) Select whether or not to add information to the SD output.
Sub-item
1 AUDIO 5CH-8CH [ON]: Add digital audio data channels 5 to 8.
OFF: Do not add digital audio data channels 5 to 8.
[ON]: Add RP188 time code data.
OFF: Do not add RP188 time code data. 2 RP188 ATC
(Continued)