Siemens Gigaset CL100 - Manual (Page 7)

7
Service making handset ready for service
Gigaset CL100 / HGK eng / A31008-A221-H100-1-7619 / starting.fm / 20.11.2003
Making the handset ready for service
Remove the protective film
The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries
◆ Insert the batteries the right way round – see illustration left.
◆ Place the cover on the battery compartment about 3 mm down from the latch and
push it up until it clicks into position.
To open the cover, press on the depression and push cover downwards.
i
◆ Use only the power supply unit supplied.
◆ If you buy another phone cable, ensure that it has the right connector
assignment for your country.
◆ Keep the power supply unit plugged in at all times to ensure your
phone is ready for use whenever you need it.
3
2
1
4
5
6
1
2
3
4
5
6
BRD
unassigned
unassigned
a
b
unassigned
unassigned
OES
unassigned
a2
a
b
b2
unassigned
Pin assignment:
W
◆ Insert only approved, rechargeable batteries of the same type
(page 25)! Never use normal batteries, since these could lead to a
health hazard or cause injury.
◆ Do not use a non-Siemens charging unit as this could damage the
batteries.