SOYO DRAGONLITE SY-KT333 - Manual (Page 25)

SY-KT333 DRAGON Lite Quick Start Guide
25
Hard disk/FDD/CD-ROM issue
My Western digital HDD is not detected during boot-up
Change the jumper settings to cable select or single.
Sometimes the system finds my CD-ROM, sometimes not
1. Check CD-ROM if it is working properly.
2. The power supply might not have enough wattage to support all the peripherals. If
your system has other peripherals connected, like CD-RW, extra HDD, etc.
disconnect them.
When I boot up my new computer I got "floppy boot failure" and the LED on the
floppy stays on
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don't
trust the "key lock" or "notch") and use the end-connector of the cable (don't use middle one).
For updated FAQs, please check http://www.soyo.com.tw/faq.htm or
http://www.soyousa.com/faqs.html