Sharp AL-1340 - Manual (Page 6)

4
1
Getting started
CAUTIONS
● Place the copier on a firm, level surface.
● Do not install the copier in a humid or dusty location.
● When the copier is not used for long time, for example for consecutive holidays,
turn the power switch off and remove the power cord from the outlet.
● When moving the copier, be sure to turn the power switch off and remove the
power cord from the outlet.
● Do not cover the copier with a dust cover, cloth or plastic film while the power
is on. Doing so may prevent heat radiation, damaging the copier.
● Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
SAFETY PRECAUTIONS
This Digital Copier is rated Class 1 and complies with 21 CFR 1040.10 and 1040.11 of
the CDRH standards. This means that the copier does not produce hazardous laser
radiation. For your safety, observe the precautions below.
● Do not remove the cabinet, operation panel or any other covers.
● The copier’s exterior covers contain several safety interlock switches. Do not bypass
any safety interlock by inserting wedges or other items into switch slots.
MAIN FEATURES
High-speed laser copying
● Since warm-up time is zero, copying can be started immediately after the power switch
is turned on.
● First-copy time is only 9.6 seconds (normal mode).
● Copying speed is 13 copies/min., which adapts to business use, allowing improvement
of working efficiency.
High-quality digital image
● High-quality image copying at 600 dpi can be performed.
● In addition to the automatic exposure mode, the manual exposure can be adjusted in
five steps.
● The photo mode copying function allows clear copying of delicate halftone original images
such as monochrome photos and color photos.