Sony HVR-M15P - Manual (Page 17)

Chapter 1 Overview
17
Chapter 1 Overview
3
Put the lid back.
Notes on batteries
• Make sure that the battery orientation is correct when
inserting batteries.
• Do not mix an old battery with a new one, or mix
different types of batteries.
• If you do not intend to use Remote Commander for a
long time, remove the batteries to avoid damage from
battery leakage. If the batteries have leaked, remove
them, wipe the battery compartment dry and replace
the batteries with new ones.
To remove the batteries
Remove the lid as step 1 and take out the batteries.
WARNING
Battery may explode or leak if mistreated. Do not
recharge, disassemble or dispose of in fire.
Check the valid date (month-year) displayed on
the batteries.
qa DATA CODE button
Press this button to display the data codes (recording
date/time, camera data).
For details on data codes, see “Displaying information
(data codes) recorded on a tape” on page 28.
qs 1 (on/standby) switch
Notes
• The command mode of the supplied Remote
commander is set to VTR4.
• Set [COMMANDER] in [OTHERS] menu to
[WIRELESS] to enable Remote Commander to
control the unit.
• In addition to Remote Commander supplied with the
unit, the unit accepts signals from any Sony Remote
Commander whose command mode is set to VTR4.
To disable the control from Remote Commander, set
[COMMANDER] in [OTHERS] menu to
[CONTROL S].
Battery installation
1
Push and slide the lid to open.
2
Install two size AA (R6) batteries (supplied) with
the correct polarity.
Be sure to install the
battery from the # side.