Smeg SLB12SB - Manual (Page 9)


$ 2SHQ GRRU EXWWRQ
Press the button to RSHQ WKH GRRU . Chapter 5 – Washing in-
structions – explains how the door works and how to use it.
% 212)) DQG ZDVKLQJ SUR
JUDPPH VHOHFWLRQ NQRE
This knob lets you:
•
switch the machine on and off by moving it in either
direction from the
2))
position (knob indicator verti-
cal)
•
select ZDVKLQJ WHPSHUDWXUHV within the various fab-
ric
VHFWRUV
by turning it in both directions
The knob does not move while the programme is running.
The programme is electronically controlled by the machine.
& 7LPH UHPDLQLQJ VKRZQ RQ
GLVSOD\ /('
This LED indicates that the display is showing the total dura-
tion of the selected programme before the programme starts,
and the time remaining while the programme is running.
' 6SLQ VSHHG VKRZQ RQ GLV
SOD\ /('
This LED indicates that the display is showing the maximum
spin speed for the selected programme. It stays on while spin
speed is being selected with the relative button.
( +HDWLQJ SKDVH /('
During the heating cycle, this LED indicates that the pro-
gramme is in the washing water heating phase.
) 'LVSOD\
The display shows the following information:
1. WLPH UHPDLQLQJ for the selected programme, given
in hours/minutes. The stated value is an estimate
based on the machine's normal operating parame-
ters (size of load, incoming water temperature, etc.).
The program time may therefore be a few minutes
longer or shorter than stated here.
2. GHOD\HG VWDUW (for models featuring this option).
Given in hours/minutes. When the time remaining
before the programme starts is less than 60 minutes,
this information is given in minutes/seconds.
3. VSLQ VSHHG
4. F\FOH SDXVH - flashing STOP
5. HQG RI F\FOH - END
6.
HUURU FRGHV
To find out which of the first 3 pieces of information are
shown on the display, check which of the LED's, C, D, or N
(the latter for models featuring the delayed start option) is lit.
* 6HOHFW VSLQ VSHHG EXWWRQ RU
VWRS ZLWK WXE IXOO
Press the button repeatedly to select the required spin
speed. The following spin speeds are available:
•

spin disabled and stop with tub full. The ma-
chine does not perform the final spin and ends the
washing programme with water in the tub. To drain
the water, see the explanations shown in paragraph
5.14
•
IURP  USP WR WKH PD[LPXP VSHHG LQGLFDWHG IRU
WKH PRGHO for FRWWRQ DQG FRORXUHG programmes,
speed increases by 100 rpm starting from 600 rpm
up to the maximum speed indicated for the model
•
IURP  WR  USP : for V\QWKHWLFV GHOLFDWHV DQG
ZRROOHQV
programmes, speed increases by 100 rpm