Sennheiser Rack-mount Receivers EM 2050 - Manual (Page 16)

Using the receiver
15
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the 2000 series with the receiver. By default,
the following parameters are transferred to the transmitter during synchronization:
To transfer the parameters:
̈
Switch the transmitter and the receiver on.
̈
Press the button ¿ on the receiver.
“ Sync ” appears on the display panel of the receiver.
̈
Place the infra-red interface of the transmitter (see the instruction manual of the trans-
mitter) in front of the infra-red interface
´ of the receiver.
The parameters are transferred to the transmitter. When the transfer is completed, “ ”
appears on the receiver’s display panel. The receiver then switches back to the current
standard display.
To cancel the transfer:
̈
Press the STANDBY button º on the receiver.
“ ” appears on the display panel of the receiver. “ ” also appears if no suitable trans-
mitter was found.
Deactivating the lock mode temporarily
You can activate or deactivate the automatic lock mode via the “ Auto Lock ” menu item
(see page 25).
If the lock mode is activated, you have to temporarily deactivate it in order to be able to
operate the receiver:
The lock mode icon ቮ flashes prior to the lock mode being activated again.
Setting Transferred parameter
“ Frequency Preset ” Currently set frequency
“ Name ” Freely selectable name currently set on the receiver
“ Pilot Tone ” Current pilot tone setting of the receiver (“ Inactive ”/“ Active ”)
Via the “ Sync Settings ” submenu, you can adjust additional parameters to be trans-
ferred to the transmitters (see page 29). It is vital to observe the notes on frequency
selection on page 31.
¿ ´
¿ ´
̈
Press the jog dial or the STANDBY button.
“ Locked ” appears on the standard display.
̈
Turn the jog dial.
“
Unlock? ” appears on the display panel.
̈
Press the jog dial.
The lock mode is temporarily deactivated.
– When you are in the operating menu, the lock mode remains deactivated until
you exit the operating menu.
– When one of the standard displays is shown, the lock mode is automatically
activated after 10 seconds.
543.200
B.Ch: 20.64 PEAK
MUTE
EQ:
+ 12dB
-10
0 40
30
20
10
-20
-30
-40
AF RF
MHz
**2000**
SKM2000
P
ቮ