Shindaiwa 81714 - Manual (Page 5)

5
5
Brushcutter Blade
Cutting
Attachment Shield
Gear Case
Throttle
Trigger
Product Description
Using the accompanying illustrations as
a guide, familiarize yourself with this unit
and its various components. See Figure 4.
Understanding your unit helps ensure top
performance, long service life, and safer
operation.
Figure 4
Specifications C3410
C3410 dry weight
(less attachments) ....................................................... 14.1 lb./6.4 kg
Engine model .........................................................................SF3410E
Engine type .......................................... with Power Boost Chamber
Bore x stroke ................................................ 1.5 x 1. in./38 x30 mm
Displacement .............................................................1 cu. in./ 34 cc
Maximum power ........................................................ 1.4 HP/1.0 kW
@ 8,000 RPM (min -1 )
Fuel/oil ratio ................................ 50:1 with ISO-L-EGD or JASO FC
class -cycle mixing oil*
Carburetor type ..................................Walbro WYL, diaphragm-type
Fuel tank capacity ...................................................... 3.7 oz./700 ml
Ignition .............................................................. One-piece electronic,
program-controlled
Spark plug ......................................................................NGK CMR5H
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
Specifications are subject to change without notice.
Air cleaner type ...................................... Non-reversible heavy-duty
filter element
Starting method ........................................................................Recoil
Stopping method .............................................................Slide switch
Transmission type .............................Automatic, centrifugal clutch
w/bevel gear
EPA Emission
Compliance Period** .......................................................Category A
** The EPA emission compliance referred to on the emission compliance label
located on the engine, indicates the number of operating hours for which the
engine has been shown to meet Federal emission requirements. Category
C = 50 hours (Moderate), B = 15 hours (Intermediate) and A = 300 hours
(Extended).
n Engine/Outer tube assembly
n Handlebar and Throttle assembly
n Cutting attachment
n Kit containing cutting attachment shield
mounting bracket and hardware, this
owner’s/operator’s manual and tool kit
for routine maintenance. Tool kits
vary by model and may include a hex
wrench set, a spark plug/screwdriver
combination wrench, and a spanner.
This unit comes fully assembled with the
exception of the handlebar cutting attach-
ment shield and cutting attachment.
* meets or exceeds these specifications and is
recommended for all Shindaiwa products.
WARNING!
Do not make unauthorized modifications
or alterations to any of these units or
their components.
C3410 BRUSHCUTTER
Outer Tube
Handle Bar
Ignition
Switch
Fuel
Tank
IMPORTANT!
The terms “left”, “left-hand”, and “LH”;
“right”, “right-hand”, and “RH”; “front” and
“rear” refer to directions as viewed by the
operator during normal operation.
Muffler
Spark Plug
Hanger
Throttle
Interlock