Sony CMT-CP101 - Manual (Page 17)

17 GB
Display/Other Features
8
Press . / > on the remote
repeatedly until the music source you
want appears.
The display changes as follows:
t TUNER y CD T
t TAPE T
9
Press ENTER on the remote.
The starting time, the stopping time, and the
music source appear in turn, then the
original display returns.
10
Press @ / 1 to turn off the system.
To
Check the settings
Turn off the timer
Tip
Once you set the timer, the time settings will remain
in the system’s memory until you change them, even
when you turn the system or the timer off. The
settings that were last used will be in effect when you
turn the timer on again.
Notes
• The system will turn on 15 seconds before the
specified starting time.
• When you have set the Sleep Timer, the Daily
Timer will not operate until the Sleep Timer
Function is turned off.
• You cannot operate the Daily Timer and the timer
recording at the same time.
Do this
Press TIMER SELECT on the
remote repeatedly until
“c DAILY” appears in the
display. The preset items
appear in turn.
Press TIMER SELECT on the
remote repeatedly until
“c DAILY” disappears from
the display.
1
Prepare the music source you want to
listen to when the system turns on.
• CD: Load a CD. To start playing from a
specific track, make a program (see
“Programming the CD tracks” on page 9).
• Tape: Load a tape with the side you want
to play facing towards you.
• Radio: Tune in the preset radio station
that you want (see “Listening to the radio”
on page 11).
2
Adjust the volume.
3
Press TIMER SET on the remote.
4
Press . / > on the remote
repeatedly until “SET DAILY” appears
in the display.
“SET DAILY” scrolls and “c DAILY”
appears in the display.
5
Press ENTER on the remote.
“ON TIME” appears, then the hour
indication flashes.
6
Set the starting time.
Press ./> on the remote repeatedly to
set the hour, then press ENTER on the
remote.
The minute indication begins flashing next.
Press ./> on the remote repeatedly to
set the minute, then press ENTER on the
remote.
“OFF TIME” appears, then the hour
indication flashes again.
7
Set the stopping time by repeating step
6.